Well Pump Replacement in Reidsville, NC
Submersible and jet pump replacement on Reidsville wells, with the drop pipe, wire, and wellhead hardware handled while the pump is already out of the casing.
A well pump replacement is the removal of a failed pump from the well and the installation of a correctly sized new one, along with the drop pipe, wire, and fittings that come up with it. Reidsville wells commonly run 150 to 350 feet, and a good share of Rockingham County properties still run decades-old jet pump setups that were never converted to submersible. T.W. Stanley & Son has been replacing well pumps across Rockingham County since 1946, and every Reidsville job gets a free written on-site estimate before anything is pulled.
What our team handles on the call
- Submersible pump replacement on drilled Reidsville wells
- Jet pump replacement and conversion on older Rockingham County systems
- Drop pipe, wire splice, and torque arrestor replaced during the pull
- Pitless adapter, check valve, and well cap replacement
- Pressure tank and switch swapped in on the same visit
- Horsepower sizing matched to well depth, measured yield, and household demand
How a service call works
- 1Free phone diagnosis
We walk through symptoms, water pressure, sounds, and system age to narrow the problem before we roll a truck.
- 2On-site test
We check voltage at the pressure switch, draw amps on the pump, and verify pressure tank pre-charge before opening anything.
- 3Written estimate
You see the recommended scope, repair vs replacement, parts, and labor in writing before any work begins.
- 4Repair or replacement
We carry common pumps, tanks, switches, and check valves on the truck so most no-water calls finish the same day they started.
- 5System test and follow-up
We cycle the system, confirm pressure holds, shock-chlorinate when needed, and stand behind the work with a labor warranty.
What does it cost?
A full submersible well pump replacement in Reidsville typically runs $1,800 to $3,800 including the pump, wire, drop pipe, fittings, and labor. Shallow well jet pump replacement usually runs $1,000 to $2,000. Depth past 350 feet, larger horsepower, corroded galvanized drop pipe, and pumps stuck in the casing push the number up. Adding a pressure tank on the same visit runs another $800 to $1,500.
- •Free phone ballpark and free written on-site estimate
- •Repair versus replacement laid out in numbers before you decide
- •No after-hours, weekend, or holiday upcharge
- •Military, fire, and police discounts
- •Manufacturer warranty on the pump plus our own labor warranty
Every job gets a written, on-site estimate before any work begins. No surprise fees.
Where we work
We replace well pumps throughout Reidsville and Rockingham County, including Wentworth, Ruffin, Eden, Madison, Mayodan, Stoneville, and the northern edge of Guilford County.
Frequently asked
How long does a well pump replacement take in Reidsville?
Most Reidsville replacements are finished in three to six hours on a single visit. Wells past 350 feet, corroded galvanized drop pipe, and pumps that are stuck in the casing are the usual reasons a job runs long or needs a second trip.
Should the drop pipe and wire be replaced with the pump?
In almost every case, yes. Both are already out of the well while the pump is up, so replacing them then costs a fraction of pulling the well again later. Old galvanized pipe and heat-damaged wire are two of the most common causes of a repeat failure in Rockingham County.
How deep are wells in Reidsville NC?
Most drilled Reidsville wells run 150 to 350 feet, with yields commonly between 5 and 20 gallons per minute. Older bored and shallow wells around Rockingham County can be far shallower, which changes both the pump type and the price of the job.
Is it worth converting an old jet pump to a submersible in Reidsville?
Often, yes, if the well is drilled deep enough to accept one. A submersible pushes water up rather than pulling it, so it delivers steadier pressure, runs quieter, and usually lasts longer than the aging jet setups still common on older Rockingham County properties.
Can you come out the same day?
Yes. No-water calls get same-day priority across the Piedmont Triad and our phone is answered 24/7. Most emergency calls are reached on-site within a couple of hours of the first call.
How much does well pump repair cost?
Most residential well pump repairs in central NC fall between $400 and $1,800 depending on the failed part, well depth, and whether the pump has to come out of the well. A full submersible pump replacement (pump, wire, drop pipe, and labor) typically runs $1,500 to $3,500. Every job gets a written on-site estimate before any work begins. Call (336) 273-7314 for a free phone diagnosis.
Do you warranty the work?
Yes. You get the full manufacturer warranty on the pump or tank plus our own labor warranty on the install. We answer the phone after the job is done.
More reading
Need help right now?
We answer the phone 24/7. Most calls are reached on-site within a couple of hours.
Call (336) 273-7314Or send a message and we will get back to you.